Installation Guide

Home / Suspension / Shocks / STS Shock Package for Sprinter 2500 2WD by Agile Offroad Installation Guide

STS Shock Package for Sprinter 2500 2WD by Agile Offroad

SKU: AOR00134

Installation Manual PDF Download Video Additional Information

Installation Manual

Required Tools:

  • Jack stands
  • Floor jack
  • Threadlocker (red)
  • 18 mm socket & wrench
  • 21 mm socket
  • Torque wrench

Installation Steps

1

Lift vehicle and support vehicle with jack stands using factory jack points. Remove the rear wheels.

2

Remove old shocks starting with the lower bolt. Discard the shocks. Save factory hardware, you’ll reuse it.

3

Clean factory hardware and apply red threadlocker before installing. The included washer goes on top bolt between shock & vehicle frame.

4

Install new shocks starting with the top bolt.

(Note: Install reservoir shocks with external reservoir facing the front of the vehicle if applicable)

5

Use a jack to help you line up the lower shock mount holes on the axle with the shock. Apply threadlocker and install lower shock hardware.

6

Torque upper shock bolt to 110 ft-lbs. Torque lower shock bolt to 75 ft-lbs. Reinstall wheels & torque lugs to 140 ft-lbs.

Congrats! Your rear shock installation is complete!