Installation Guide

Home / Interior / Storage & Organization / Overhead Switch-Pros Mount for Sprinter by Agile Offroad Installation Guide

Overhead Switch-Pros Mount for Sprinter by Agile Offroad

SKU: AOR3333, AOR-3333-1, AO-E4S-X

Installation Manual PDF Download Additional Information

Installation Manual

General Information

The AO Overhead Switch Pros Mount is designed to be installed on the factory overhead control panel of 2019+ Sprinter vans. We recommend the Overhead Mount be installed by an authorized AO dealer (refer to agileoffroad.com to find a dealer near you).

Read the instructions completely before starting the installation process.

Parts Included

Part # AOR3333:

1 x AO Overhead Switch Mount

Refer to the Switch Pros for wiring instructions.

Tools Needed

Credit Card
1/4” Drill Bit
Step Bit - 3/4”
Phillips Screwdriver

Installation Steps

Use your favorite credit card and slide it in the gap between the overhead control panel and the outer trim. This will release the front of the control panel and will allow the panel to swing forward.

Locate and disconnect any wire connectors before attempting to remove the control panel.

2b. To remove the white connector, depress the locking tab (shown above) while pulling on the connector.

2c. To remove the blue connector, depress the locking tab (shown above) while pulling apart both male and female connectors.

Slide the control panel back and remove completely.

Open the eyeglass compartment. Remove the compartment door by pulling the door to the right while pulling up. Then remove the elastic cord from panel.