Installation Guide

Home / Suspension / Suspension Parts / Apex airLYNX Adjustable Disconnect for INEOS Grenadier by Agile Offroad Installation Guide

Apex airLYNX Adjustable Disconnect for INEOS Grenadier by Agile Offroad

SKU: AO-S4G-X

Installation Manual PDF Download Additional Information

Installation Manual

The Apex airLYNX Front Adjustable Disconnect by Agile Offroad lets you fine-tune your INEOS Grenadier’s suspension behavior to match any driving condition. With a 0–300 PSI adjustment range, you can easily dial in sway bar stiffness, soft for maximum off-road flex, or firm for precise on-road control.

Unlike traditional disconnects that require manual removal, airLYNX offers instant, on-the-fly adjustability. Drop pressure to 0 PSI for unrestricted articulation or raise it to 150–300 PSI for predictable handling and reduced body roll on pavement. Built from high-strength materials, the system installs as a bolt-on upgrade designed for durability in rugged environments.

Each kit includes a Fox shock pump for precise air control. The optional remote fill system relocates air fittings to easily accessible mounting points, allowing quick adjustments without accessing the undercarriage, ideal for overland or off-road use.

SKU: AO-S4G-1

PARTS INCLUDED

  • 1 x Driver Side airLYNX
  • 1 x Passenger Side airLYNX
  • 1 x Fox Shock Pump
  • 2 x M12 Bolt
  • 2 x M12 Washer
  • 4 x M12 Spacer
  • 2 x M12 Lock Nut

TOOL NEEDED

  • 18mm Wrench/Socket
  • 19mm Wrench/Socket
  • T40 Torx Bit
  • 6mm Allen Wrench

INSTALLATION TIME: 30 Minutes

Installation Steps

1

The Apex airLYNX are side specific. Identify the correct link for the side you are working on.

2

Use two 18mm wrenches to remove the two outer factory sway bar link nuts. Use an 18mm wrench and a T40 Torx bit to remove the two inner factory sway bar link nuts. Remove sway bar link.

3

Assemble the side specific airLYNX as shown using one of the supplied M12 spacers on the top stud and the M12 bolt and spacer on the bottom.

4

Install the airLYNX on the outside of the sway bar using the supplied M12 flat washer and M12 lock nut.

5

Install the airLYNX to the axle housing mount using the supplied M12 flat washer and M12 lock nut.

6

Use a 19mm wrench and a 6mm Allen wrench to fully tighten to upper link hardware. Use two 19mm wrenches to fully tighten the lower link hardware. Torque to 70 ft lbs. Repeat steps 1-6 on the opposite side.

Note: airLYNX shown here with the optional remote fill kit.

RECOMMENDED DIRECTIONS TO USE:

  1. The airLYNX system is entirely adaptable, so each driver can choose the ideal pressure settings based on the situation.
  2. Agile Offroad suggests the following airLYNX pressure guidelines:
  • Lowest pressure: 0 psi
  • Highest pressure: 300 psi
  • For on-road conditions: maintain between 150 and 300 psi
  • For off-road conditions: maintain between 0 and 150 psi